Rapid Search

Find SPIROL products fast.

Optimal Application Engineering

Design the most cost effective fastening solution.

Your Location

For best online service, please change location if not correct.

Your Language

Please select your preferred language.

Compression Limiters

Compression Limiters

The primary function of a Compression Limiter is to provide and maintain joint integrity of a plastic assembly.  They are designed to protect the plastic components of an assembly from the compressive loads generated by the tightening of the bolts, thereby assuring integrity of the bolted connection.

SPIROL offers nine standard series of Compression Limiters to accommodate different compressive loads, positional tolerances and installation methods.  SPIROL’s Series CL200 and CL350 split seam Limiters are produced with flexible diameters to compensate wide hole tolerances.  The Series CL400 Oval Press-In Compression Limiter accommodates up to 2.25mm extra clearance on one axis, providing additional flexibility over round Limiters for centerline and stack-up tolerancing.

The Series CL500 Molded-In Compression Limiter is produced with a butted-seam to prevent plastic from entering the inner diameter during the molding process.  The Series CL460 Series Oval Molded-In is similar to the oval series CL400, but, similar to the CL500, produced with a butted-seam so as to prevent plastic from entering the inner diameter during the molding process.

The Series CL600, CL601, CL800 and CL801 machined Compression Limiters can all be either pressed in or molded into the assembly.  The CL600 is machined from aluminum which is lightweight, strong and lead free.  The CL601 headed aluminum Limiter is the same as the Series CL600, with the addition of a head. The CL800 is machined from brass.  The applications for SPIROL’s brass and aluminum Compression Limiters are very similar, however, to accommodate the same class/grade bolt, the brass Limiters have a larger wall thickness due to the material’s lower yield strength.  The CL801 headed brass Compression Limiters are the same as the CL800 with the addition of a head.

SPIROL offers standard installation equipment for post-mold Compression Limiter installation

Search for a specific standard Compression Limiter below or download the Compression Limiters Design Guide.

Download 2D/3D drawings of SPIROL's Compression Limiters.

Rapid Search for Compression Limiters

To find a standard part, please select the following specifications in the order they appear.

Part Code:

Inch/Metric
Series
Bolt Size
Length
Material
Finish
Start Again

If this part does not meet your requirements, use our Optimal Application Engineering process in the left column to quickly evaluate and optimize your fastening or assembly application.